REIPL

This command allows the user to automate the re-booting (re-IPLing) of the system following an IPE.

Syntax.

     REIPL=ON | OFF

Parameters

ON

This specifies the system it to be automatically re-booted following an IPE.
OFF
This specified that the system is not to be automatically re-booted following an IPE. The system will remain hung until manually restarted.

Notes:

REIPL only applied to pre-WARP systems if APAR PJ12258 has been applied.

REIPL has no effect when TRAPDUMP=ON|R0 is specified. Whether the system is re-booted following a stand-alone dump is governed by the OS2DUMP module. If the the dump is to hard-disk then automatic re-boot occurs, otherwise not.

---

[Back: DUMPPROCESS]
[Next: RASKDATA]